Security Alarms AR6000 Guía de usuario descargar pdf (Pagina 62)

62 SPEKTRUM DX6 • HELICOPTER PROGRAMMING GUIDE

CHAPTER 3: KEY INPUT AND DISPLAY

KEY INPUT AND DISPLAY

Two input keys are located at the lower faceplate of the DX6 transmitter. The keys are used to access and

program the transmitter. Each key can be moved up or down using your thumbs

 

















CHAPTER 4: BATTERY ALARM AND DISPLAY

When the transmitter battery drops below 9.0 volts, the display will start to ﬂash “BAT” and an audible alarm will

sound eight times. This warning indicates a low battery condition and you should land your aircraft immediately.





Note: During the period that the battery alarm is flashing, the input buttons will not function. If

you are currently in the function mode, the transmitter will exit automatically and return to the

normal display.

THROTTLE CUT

Your DX6 incorporates a special THROTTLE CUT Function. The throttle cut button is located on the upper right

face of the transmitter. This feature is designed primarily for glow-powered aircraft and is designed to shut off

the engine when pressed without affecting the throttle trim position. With the throttle stick in the low position,

pressing the throttle cut button with drive the throttle servo to its programmed low throttle, low trim endpoint

adjusted in travel adjust. This will not be a commonly used feature for parkﬂyer aircraft.

Note: The Throttle Cut function is designed to function only when the throttle stick is below the

1/2 position.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 95 96

Sin comentarios

Security Alarms AR6000 Guía de usuario Pagina 62