77SPEKTRUM DX6 • DX6 HELICOPTER PROGRAMMING GUIDE
THROTTLE HOLD
The throttle hold function enables the throttle to be held in a specific location, while allowing the remaining
channels to function normally. The purpose of this function is for autorotation landings, however, many pilots
find throttle hold useful as an arming switch for electric helicopters to prevent the motor from accidentally
running if the sticks or switches are bumped, or in the wrong position. When the throttle hold function is
activated, a third adjustable pitch curve is available in the pitch curve screen. The throttle hold switch is located
on the top right rear corner of the transmitter. Throttle hold is on when the switch is in the forward position.
�
ACCESSING THE THROTTLE HOLD FUNCTION
1. Turn on the transmitter.
2. Press the SCROLL and INCREASE buttons simultaneously to enter the Function mode.
3. Press the SCROLL button until “HLD” appears on the screen.
4. The factory setting for the Throttle Hold function is off.
Note: When the Throttle Hold function is off, the throttle hold pitch curve will not appear in the
pitch curve function. Press the
INCREASE or DECREASE button to activate the Throttle Hold
function. The throttle hold pitch curve will now appear in the pitch curve function. To inhibit the
Throttle Hold function, press the
CHANNEL and INCREASE buttons simultaneously.
5. Using the INCREASE or DECREASE button, adjust the throttle hold value to the desired position, the normal
range of throttle hold is from -2 (1/2 trim) to +15 (full high trim).
6. Press the SCROLL button to access the pitch curve function.
7. To exit, press the
SCROLL and INCREASE buttons simultaneously.
Comentarios a estos manuales